Schneider Electric support forum to share knowledge about product selection, installation and troubleshooting for EcoStruxure Panel Server, PowerTag, Com'X, Link150…
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
2015-03-1009:05 AM
PowerLink G3 Breaker Control using AS
Are the MODBUS Tables available for the PowerLink G3 breakers/Controller? I would like to not use the NF3000G3 controller and connect an Automation Server directly to the NFSELG3 Slave Address Select Module to control the breakers. Is this possible?