Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Link copied. Please paste this link to share this article on your social media post.
Hello,
I am trying to connect EGX300 and IEM3150 via modbus cable ,
can anyone help me what is the correct connection between two connector as in the picture?
for example:
Tx + D1/+
Tx- D0/-
Q Q
Rx- 0V
Link copied. Please paste this link to share this article on your social media post.
You have to do the following settings and wiring connection as this information is already there in the Installation sheet of EGX300..
Please find the link to download the document for EGX300.
PowerLogic EGX300 - Documents & Downloads
Hope this helps you.
Regards,
Kamal Kumar
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.