EcoStruxure Power Design Forum
Schneider Electric support forum to share knowledge about installation and usage for Electrical Network Design and Calculation Software (Ecodial, Ecostruxure Power Design).
Link copied. Please paste this link to share this article on your social media post.
Posted: 2022-06-29 05:56 AM
Greetings,
I humbly seek guidance in creating network that has independent power sources. Primary source is derived with solar 45 kva with a secondary back-up source a generator 50kva. Both supplying independent prepaid sources as Zone A and Zone B to distribution boards zones A and B, respectively.
Attached is what I want to achieve using Ecostruxure Design Ecodial. I am not too sure how to represent the drawing that it be understood by the software.
I am still new in using it
Thanks
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2022-06-30 10:12 PM
Hello,
Greeting for the day, and thanks for your email.
The EcoStruxure Power Design - Ecodial, does not have the "SOLAR POWER SOURCE" options to represent them. The zone A (that you mentioned) is not possible for relaize.
Whereas; Generator as a source is available for representation, and that can be realized.
So the network section zone B is possible to realize.
If you are using 2 source in a network, then it will be good to use 'the operating modes functionality' to define the 'different operting scenarios.'
For more information on the operating modes; kindly please review the following video;
https://www.youtube.com/watch?v=zeRrPnRiQpE
Thanks & Regards,
Team - Ecodial Expert Support
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2022-06-30 10:12 PM
Hello,
Greeting for the day, and thanks for your email.
The EcoStruxure Power Design - Ecodial, does not have the "SOLAR POWER SOURCE" options to represent them. The zone A (that you mentioned) is not possible for relaize.
Whereas; Generator as a source is available for representation, and that can be realized.
So the network section zone B is possible to realize.
If you are using 2 source in a network, then it will be good to use 'the operating modes functionality' to define the 'different operting scenarios.'
For more information on the operating modes; kindly please review the following video;
https://www.youtube.com/watch?v=zeRrPnRiQpE
Thanks & Regards,
Team - Ecodial Expert Support
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.