EcoStruxure Power Design Forum
Schneider Electric support forum to share knowledge about installation and usage for Electrical Network Design and Calculation Software (Ecodial, Ecostruxure Power Design).
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-09-07 07:55 PM . Last Modified: 2024-11-22 04:25 AM
I cannot see the calculation result when I run the analysis. I get this error
I checked the network connection and it is good.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-09-09 11:37 PM
Hello Ariel
Thanks for your interest in Ecodial.
Can you please use the ‘operating modes’ feature to overcome your scenario.
The operating modes is explained at the following video.
Regards,
Team – Ecodial Expert Support.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-09-09 11:37 PM
Hello Ariel
Thanks for your interest in Ecodial.
Can you please use the ‘operating modes’ feature to overcome your scenario.
The operating modes is explained at the following video.
Regards,
Team – Ecodial Expert Support.
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2024-09-11 08:01 AM
Thank you for your help. After using the operating mode feature, the short circuit result can be seen.
Link copied. Please paste this link to share this article on your social media post.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.