Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
EcoStruxure Power Design - Ecodial INT 4.9.7 - The CIRCUIT NAME is now as part of the Data Table and Solution Table
EcoStruxure Power Design Forum
Schneider Electric support forum to share knowledge about installation and usage for Electrical Network Design and Calculation Software (Ecodial, Ecostruxure Power Design).
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
The CIRCUIT NAME is now as part of the Data Table and Solution Table.
- Draw the electrical network, on the Ecodial application (at the Design & Sizing Tab) as per the requirements.
- Provide all the necessary inputs to the loads and circuits.
- DATA TABLE can also be used to provide inputs for the “components like Cable, load, protection and so on.”
- Calculate the project as usual.
- Once after the successful completion of the project calculation; As part of the report generation, please click on the SOLUTION TABLE.
- We can see the component results (solutions) are grouped as per their CIRCUIT NAME.
Additional Benefit:
All the content of the Data Table & Solution Table can be exported in EXCEL, and they can be easily recognized as per the associated “CIRCUIT NAME” and using their “COMPONENT NAME.”
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.