Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84392members
353580posts

Easy UPS 3 Series Network Card

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

Mr_T
Ensign
Ensign

Easy UPS 3 Series Network Card

Hi All

 

I have an Easy UPS 3 Series Network Card (E3SOPT001) that I wish to configure on a 3 Phase Easy UPS.

The SNMP Card manual says that I should get the IP Address for the Card from "Easy UPS 3PH SNMP Manager" however I am not finding this Software on apc.com.

 

Has anyone configured this Card before and can assist with directions on how to go about it?

 

Thank you in advance.

 

Please see image below:

 

 
 
 
 

SNMP.PNG

Tags (3)
1 Reply 1
sesa90965_bridg
Ensign Ensign
Ensign
0 Likes
0
488

Re: Easy UPS 3 Series Network Card

Hi Mr_T,

 

in documentation of the older 802 nmc card i have found this:

 

Easy UPS default IP en inlog credentials

192.168.5.105

default username and password = administrator/administrator

 

the card has a static ipadres when it comes from the factory, so connect directly to this IP and you can login.

Tags (1)