Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84589members
353854posts

Q radio firmware upgrade using TVIEW

Remote Operations Forum

Collaborate and share knowledge on the extensive range of remote systems and devices, including SCADA radios and RTUs, on the Schneider Electric Exchange Remote Operations (formerly SCADA & Telemetry) forum. From commissioning SCADA integration devices and software, to enhancing existing installations or troubleshooting, connect with a global community of experts and users. Subscribe today.

Solved
bigdaz
Ensign
Ensign
0 Likes
1
1357

Q radio firmware upgrade using TVIEW

Hi trying to use TVIEW 3/27/0 to upgrade firmware on the Q radios to firmware 2.2.5.6746. However once the firmware zip file is selected and upload firmware chosen it appears to only progress 200/3952417 then will say upgrade complete after period of time. The new firmware obviously is not visible as the alternate on the list. All are currently using firmware 2.1.8


Accepted Solutions
Joel_Weder
Commander Commander
Commander
0 Likes
0
1334

Re: Q radio firmware upgrade using TVIEW

Sounds like you are attempting to do a Broadcast firmware upgrade to several Q radios. (or perhaps just to one radio, but over the air) An informal procedure for doing this is attached. A couple of notes to be really clear about:

- It's critical all devices (computer port setup, software tool, ALL radios) use the same IP mask

- The entry point radio must have its filtering firewall set to Allow All. (at least temporarily)

 

If you continue to have issues after following the attached procedure, please contact our Tech Support team. They can typically deal with time-sensitive support issues more quickly.

 

SupportTRSS@se.com  or...

1-888-226-6876

 

Joel Weder
Remote Operations Specialist
Schneider Electric

See Answer In Context

Attachments
1 Reply 1
Joel_Weder
Commander Commander
Commander
0 Likes
0
1335

Re: Q radio firmware upgrade using TVIEW

Sounds like you are attempting to do a Broadcast firmware upgrade to several Q radios. (or perhaps just to one radio, but over the air) An informal procedure for doing this is attached. A couple of notes to be really clear about:

- It's critical all devices (computer port setup, software tool, ALL radios) use the same IP mask

- The entry point radio must have its filtering firewall set to Allow All. (at least temporarily)

 

If you continue to have issues after following the attached procedure, please contact our Tech Support team. They can typically deal with time-sensitive support issues more quickly.

 

SupportTRSS@se.com  or...

1-888-226-6876

 

Joel Weder
Remote Operations Specialist
Schneider Electric
Attachments