Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84398members
353586posts

[Imported] RealFLO Register Overlap

Remote Operations Forum

Collaborate and share knowledge on the extensive range of remote systems and devices, including SCADA radios and RTUs, on the Schneider Electric Exchange Remote Operations (formerly SCADA & Telemetry) forum. From commissioning SCADA integration devices and software, to enhancing existing installations or troubleshooting, connect with a global community of experts and users. Subscribe today.

sbeadle
Janeway Janeway
Janeway
0 Likes
0
752

[Imported] RealFLO Register Overlap

>>Message imported from previous forum - Category:Realflo Electronic Flow Measurement<<
User: mchartrand, originally posted: 2018-10-17 19:05:18 Id:89
This is a re-posting from the obsoleted (October 2018) "Schneider Electric Telemetry & SCADA" forum.

-------------------------------

**_Berkelium:
Reading the RealFLO 6 TeleBUS protocol reference manual, it would appear that there is a register overlap between the AGA-7 configuration structures and the V-Cone Point 4 Reynold's Number and CoEfficient config. and actual registers.
Is the manual correct? If so, are there any other known registers that overlap in RealFLO?_**

__________________________________

mchartrand:
I believe that because V-Cone or AGA-7 cannot be configured at the same time, i.e. the flow computer can only do one type of flow calculation per flow run, that there may be some overlap of registers in certain places. We had to make use of a limited number of Modbus registers so there are certain blocks of them that do double duty.