Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel

[Imported] Do SCADAPack 333E and 535E Support Time Synchronisation via IRIG-B?

Remote Operations Forum

Collaborate and share knowledge on the extensive range of remote systems and devices, including SCADA radios and RTUs, on the Schneider Electric Exchange Remote Operations (formerly SCADA & Telemetry) forum. From commissioning SCADA integration devices and software, to enhancing existing installations or troubleshooting, connect with a global community of experts and users. Subscribe today.

Janeway Janeway

[Imported] Do SCADAPack 333E and 535E Support Time Synchronisation via IRIG-B?

>>Message imported from previous forum - Category:SCADAPack RTU<<
User: mchartrand, originally posted: 2018-10-18 20:15:11 Id:139
This is a re-posting from the obsoleted (October 2018) "Schneider Electric Telemetry & SCADA" forum.


Does anyone know if the SCADAPack 333E or 535E Support Time Synchronisation via an IRIG-B signal? If not is there a plan to release this in the near future?_**


Negative, not without additional hardware (to essentially turn IRIG-B into NTP).

The only SCADAPack item that supported out of the box IRIG-B is the SCADAPack ER with the P620 processor. I would not recommend this moving forwards.


Thanks for the Reply Bevan_**