Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84244members
353344posts

[Imported] Clearscada 2015 r2 sms basic pager channel setup

Remote Operations Forum

Collaborate and share knowledge on the extensive range of remote systems and devices, including SCADA radios and RTUs, on the Schneider Electric Exchange Remote Operations (formerly SCADA & Telemetry) forum. From commissioning SCADA integration devices and software, to enhancing existing installations or troubleshooting, connect with a global community of experts and users. Subscribe today.

sbeadle
Janeway Janeway
Janeway
0 Likes
0
446

[Imported] Clearscada 2015 r2 sms basic pager channel setup

>>Message imported from previous forum - Category:Communications Products <<
User: mchartrand, originally posted: 2018-10-25 17:39:53 Id:257
This is a re-posting from the obsoleted (October 2018) "Schneider Electric Telemetry & SCADA" forum.

_______

**_ebouthillier:
We are currently using clearscada 2015 R2 with a cradlepoint IBR650E-VZ cell modem. We would like to send alarms to and operator cell phone so he can be mobile around the plant. The modem is set up with an IP address. When I try to configure the SMS pager channel I get an error that reads "(unable to connect to TCP/IP Port)". No matter what port I use. Is there set port I need to be using?_**

__________

bevanweiss:
Does the IBR650E-VZ modem support a telnet AT command interface?
If so, then you would want to use the port that it supports this interface on.

It would also need to support the appropriate SMS sending commands that ClearSCADA is expecting it to, which has in the past been quite an issue.