New Features

[vsb]

Hello,

"Dummy Load" under load category and "Default Minimum Permissible Cross-Sectional Area of Cable" parameter under Project Parameters would be great features.

Regards

Savas Akyavas

[Genghiz · Accepted solution]

Hello

Thanks for reaching the EcoStruxure Power Design Forum.

Default min CSA:

As suggested, we will consider this point under the product development backlog. We will recommend the product management to prioritize the same.

Dummy load:

The existing load component can be used as a dummy load in the following two ways.

• Define the load and use the “Ku” to minimize its consumption to a bar minimum.
• Define the load and make it not consuming or not working in a operating mode.

Thanks & Regards,

Team – Ecodial Expert Support.