Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84589members
353855posts

Motion control in Unity Pro 13.1

Modicon PAC Forum

A forum for topics related to the scope of Modicon PAC offers and ecosystem along the whole lifecycle: Modicon M580 and 340, EcoStruxure Control Expert, EcoStruxure Process Expert (Unity Pro) and more.

amikhailov
Cadet

Motion control in Unity Pro 13.1

I wonder how could I add the MDrive Plus (CAN version) to Unity PRO "Motion" section. Is it possible to get the correct MFB or a just piece of advice?

Tags (1)
1 Reply 1
AlastairF
Lieutenant Lieutenant
Lieutenant

Re: Motion control in Unity Pro 13.1

You need to add the eds file to the Unity Pro CAN hardware library using the Hardware Library Manager.

I'm not sure how compliant the MDrive eds file is against the CAN standards. The HLM reported a few errors on import.

 

Then the device will be available to selected (within Unity Pro/ Control Expert) from the Hardware Library as a CANopen device.

Unfortunately it is not possible to add this with MFB support.

Tags (1)