Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

Close
Important Announcement: WELCOME to the new Schneider Electric Community! Community is now no longer part of Exchange, and is now rebranded under se.com. If you have any bookmarks and links saved, we request you to update them to ensure that you continue accessing our community from this new location. For any issues that you might encounter as part of this change, please reach out to SchneiderCommunity.Support@se.com, and the team will help to get your issues resolved.
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
82302members
349836posts

Rack Access user credentials - mass configuration with DCE

EcoStruxure IT forum

A support forum for Data Center Operation, Data Center Expert, and EcoStruxure IT product users to share knowledge on installation, configuration, and general product use.

Slavek_13
Crewman Crewman
Crewman

Rack Access user credentials - mass configuration with DCE

Hi,

We are trying to integrate more than 120 racks with NBRK0250+NBHN1336 inside each with DCE and mass set up user's access rights (no Radius server, only local db).

Using APC SNMP Device Configuration feature we've programmed some users cards but currently we need to remove some of them and add another. Adding ne cards works  but ... the we can't remove unnecessary ones using DCE, works only manually on each NBRK unit separately ... and this is Sisyphean work 😞

Checking results upon Incomplete Configuration we found all users intended to delete as unchanged.

We've tried also upload modified config.ini, but without success ... users still unchanged.

Could you please suggest solution?

NBRK FW 7.0.4/7.0.6

 

Thank you in  advance,

Slavek

Tags (1)