Follow along for an enriching discussion with our CEO, Peter Herweck, and industry leaders for a captivating Global Keynote at #InnovationSummit Paris 2024. Watch recording and join the #ImpactMaker movement!️
AP9641 Flapping
Ask the Community
Ask questions, get advice from experts and peers on Digital Automation & Energy Management.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2022-09-2711:23 AM
AP9641 Flapping
We just installed two Smart-UPS SRT 2200 UPSs at different locations on our network. Each of them has an AP9641 NMC card.
After they were installed, the switch port for the NMC started bouncing numerous times every minute...about once every 10-20 seconds. We tried using a different switch port, different Cat-6 patch cable, even swapping out the entire UPS. None of these stopped the UPS' port from bouncing.
I noticed today that running a continual ping to the UPS' NMC will stop the flapping. When I stop the ping, the port flapping returns. I was able to upgrade the firmware on the NMC to v2.2.0.1, but that didn't help.