Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84331members
353498posts

stop the PCNS shutdown process when Input Power Restored

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

Solved
mah_apc
Crewman
Crewman
0 Likes
4
444

stop the PCNS shutdown process when Input Power Restored

This was originally posted on APC forums on 12/27/2012


when the ups goes on battery the shutdown process begin after few minutes ,but when the power restore ,the PCNS still continues the shutdown process, how can I configure the powerchute or ups to stop shutdown process after the power restored !!!???

Tags (2)

Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
444

Re: stop the PCNS shutdown process when Input Power Restored

This reply was originally posted by Jonathan on APC forums on 12/28/2012


That's how our software are configured, once it calls the shutdown process there is no way to stop it.

See Answer In Context

4 Replies 4
mah_apc
Crewman
Crewman
0 Likes
0
444

stop the PCNS shutdown process when Input Power Restored

This was originally posted on APC forums on 12/27/2012


when the ups goes on battery the shutdown process begin after few minutes ,but when the power restore ,the PCNS still continues the shutdown process, how can I configure the powerchute or ups to stop shutdown process after the power restored !!!???

BillP
Administrator Administrator
Administrator
0 Likes
0
444

Re: stop the PCNS shutdown process when Input Power Restored

This reply was originally posted by Angela on APC forums on 6/24/2013


You'll need to manually turn it on somehow either via the power switch on the server or perhaps with a switched rack PDU for example if your computer BIOS is set to last AC state to cycle the power to the server so it comes on to its "last state" of on. You can also reboot your entire UPS output to do that same power cycle to the equipment to have it come back on.

voidstar_apc
Janeway
Janeway
0 Likes
0
444

Re: stop the PCNS shutdown process when Input Power Restored

This was originally posted on APC forums on 6/25/2013


Set PCNS to turn off the UPS as well. Then set the computer's BIOS settings to turn back on after a power failure, or return to last state.

BillP
Administrator Administrator
Administrator
0 Likes
0
445

Re: stop the PCNS shutdown process when Input Power Restored

This reply was originally posted by Jonathan on APC forums on 12/28/2012


That's how our software are configured, once it calls the shutdown process there is no way to stop it.