Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84568members
353835posts

new AP9631 in "old" Matrix 5000

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

Solved
JohnEricsson_apc
Cadet
0 Likes
1
84

new AP9631 in "old" Matrix 5000

This was originally posted on APC forums on 11/27/2010


We have yet to purchase the monitoring card.

The firmware of the MATRIX is "5ZI"
(manufacture Date: 04/08/03)

If someone could advise on the comptability with the AP9631 I would appretiate it.

thank you


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
84

Re: new AP9631 in "old" Matrix 5000

This reply was originally posted by Angela on APC forums on 11/29/2010


keep in mind the matrix has been discontinued for some time. the AP9630 or AP9631 should support the matrix, as the AP9617 does but it was not officially tested since it has been discontinued. the code for it was copied over from the AP9617 though so I would advise you that it should be compatible but if you run into issues, we may not be able to fix any problems with it as we would with a currently manufactured UPS.

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
85

Re: new AP9631 in "old" Matrix 5000

This reply was originally posted by Angela on APC forums on 11/29/2010


keep in mind the matrix has been discontinued for some time. the AP9630 or AP9631 should support the matrix, as the AP9617 does but it was not officially tested since it has been discontinued. the code for it was copied over from the AP9617 though so I would advise you that it should be compatible but if you run into issues, we may not be able to fix any problems with it as we would with a currently manufactured UPS.