Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84558members
353825posts

System failure Detected by Surveillance

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

rGp_1_apc
Cadet
0 Likes
0
237

System failure Detected by Surveillance

This was originally posted on APC forums on 10/23/2015


That message appear on my 2 units UPS SUVT 30 kva,

UPS 1. From the first installation Never Used for Load powered, Run it just for Charging Batteries, sometimes i do execute perform power fail simulation and its ok but now it show the message and fault led appear..! Please help what the message mean?

UPS 2. I'm not sure but  recently maybe there are short circuit on ups loads, and UPS now bypass led appear. the question : why the UPS still bypass state even no more short circuit on loads?

Thanks