Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84865members
354354posts

RC100 - how to interface to BMS system that communicates via BACnet

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

Solved
karbonphiber_apc
Lieutenant JG
Lieutenant JG
0 Likes
1
142

RC100 - how to interface to BMS system that communicates via BACnet

This was originally posted on APC forums on 12/30/2011


Anyone have experience/knowledge on how to interface the RC100 to a BMS system that communicates via BACnet?

Message was edited by: karbonphiber


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
142

Re: RC100 - how to interface to BMS system that communicates via BACnet

This reply was originally posted by Angela on APC forums on 1/2/2012


unfortunately, the RC network management card doesnt support BACnet at all so i think you will need an SNMP or Modbus to BACnet gateway of some type from what i have heard.

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
143

Re: RC100 - how to interface to BMS system that communicates via BACnet

This reply was originally posted by Angela on APC forums on 1/2/2012


unfortunately, the RC network management card doesnt support BACnet at all so i think you will need an SNMP or Modbus to BACnet gateway of some type from what i have heard.