Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84364members
353550posts

PowerChute keep send shutdown command to client

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

Solved
BillP
Administrator Administrator
Administrator
0 Likes
1
165

PowerChute keep send shutdown command to client

This question was originally posted by Md. Shahadat on APC forums on 5/9/2016


I have configured APC Network Management card and truing to shutdown server before it drain out.

one of Linux server i have added  to PowerChute client and configure shutdown time. 

after first time tested it works fine. now when ever the client power on it send a shutdown signal to client and it shutdown. 

need help.


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
165

Re: PowerChute keep send shutdown command to client

This reply was originally posted by Bill on APC forums on 5/9/2016


Hi,

It sounds like you configured PCNS to start a shutdown when available runtime as been exceeded. We have Knowledge Base document FA241713 that will help with this. To get the system running increase the low battery threshold on the NMC. That should stop the power down cycle. 

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
166

Re: PowerChute keep send shutdown command to client

This reply was originally posted by Bill on APC forums on 5/9/2016


Hi,

It sounds like you configured PCNS to start a shutdown when available runtime as been exceeded. We have Knowledge Base document FA241713 that will help with this. To get the system running increase the low battery threshold on the NMC. That should stop the power down cycle.