Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84622members
353937posts

PX80 static switch fault

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

Solved
BillP
Administrator Administrator
Administrator
0 Likes
1
283

PX80 static switch fault

This question was originally posted by terrence on APC forums on 7/19/2019


Good Day, 

I am having an issue with a PX 80KVA, the unit is saying the static switch is faulty, the static switch was replaced with a new one from APC but the fault remained, it is also saying in the logs "communications established" every few minutes, could this be one or both intelligence module(s) are faulty?


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
283

Re: PX80 static switch fault

This reply was originally posted by KASSEM on APC forums on 8/6/2019


Hi, nobody answer to you? I experience the same on symetra PX: static by-pass module switch fault" alarm.

I open and close again the Q5 breaker ( static by-pass and the alarm disapear. But i didn't receive an answer from Apc explained this..  

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
284

Re: PX80 static switch fault

This reply was originally posted by KASSEM on APC forums on 8/6/2019


Hi, nobody answer to you? I experience the same on symetra PX: static by-pass module switch fault" alarm.

I open and close again the Q5 breaker ( static by-pass and the alarm disapear. But i didn't receive an answer from Apc explained this..