Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84475members
353693posts

Need to Configure AP9619 IP Address

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

Solved
johnmc_apc
Crewman
Crewman
0 Likes
1
289

Need to Configure AP9619 IP Address

This was originally posted on APC forums on 6/10/2019


Hi,

I have an AP9619 Network Management Card connected to our APC Smart-UPS 5000VA 208V and I need to set the IP address of the Network Card using a local computer. The Installation and Quick-Start manual (https://www.apc.com/salestools/ASTE-6Z5QDZ/ASTE-6Z5QDZ_R0_EN.pdf) says to connect to the serial port on the face of the card, but the AP9619 does not have a serial port on its face. How do I get access to the Network Management Card itself?

Thanks.


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
289

Re: Need to Configure AP9619 IP Address

This reply was originally posted by Bill on APC forums on 6/11/2019


Hi,

You connect the serial cable to the serial port on the UPS. You will communicate with the NMC through that connection. 

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
290

Re: Need to Configure AP9619 IP Address

This reply was originally posted by Bill on APC forums on 6/11/2019


Hi,

You connect the serial cable to the serial port on the UPS. You will communicate with the NMC through that connection.