Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84589members
353857posts

Can you change the NMC user logon timeout?

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

Solved
dsalzedo_apc
Ensign
Ensign
0 Likes
2
450

Can you change the NMC user logon timeout?

This was originally posted on APC forums on 11/25/2013


I am running v6.06 FW on AP9631 NMC2's. Is there a way to change the timeout for user sessions? By default it seems to be less than 10 minutes which is often frustratingly short, especially when you have multiple NMC's to change.

Thanks,

Daniel.


Accepted Solutions
voidstar_apc
Janeway
Janeway
0 Likes
0
449

Re: Can you change the NMC user logon timeout?

This was originally posted on APC forums on 11/26/2013


Check under Configuration->Security->Local Users->Management. Then select a user and alter the session timeout.

See Answer In Context

2 Replies 2
voidstar_apc
Janeway
Janeway
0 Likes
0
450

Re: Can you change the NMC user logon timeout?

This was originally posted on APC forums on 11/26/2013


Check under Configuration->Security->Local Users->Management. Then select a user and alter the session timeout.

dsalzedo_apc
Ensign
Ensign
0 Likes
0
450

Re: Can you change the NMC user logon timeout?

This was originally posted on APC forums on 11/26/2013


That was it, thanks!