Ask Me About Webinar: Data Center Assets - Modeling, Cooling, and CFD Simulation Join our 30-minute expert session on July 10, 2025 (9:00 AM & 5:00 PM CET), to explore Digital Twins, cooling simulations, and IT infrastructure modeling. Learn how to boost resiliency and plan power capacity effectively.Register now to secure your spot!
APC Smart UPS 3000 Runtime Problem
APC UPS Data Center & Enterprise Solutions Forum
Schneider, APC support forum to share knowledge about installation and configuration for Data Center and Business Power UPSs, Accessories, Software, Services.
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
You have entered an invalid email address. Please re-enter the email address.
This co-worker has already been invited to the Exchange portal. Please invite another co-worker.
Please enter email address
Send InviteCancel
Invitation Sent
Your invitation was sent.Thanks for sharing Exchange with your co-worker.
Link copied. Please paste this link to share this article on your social media post.
Posted: 2021-07-0710:33 PM. Last Modified: 2024-03-0112:31 AM
APC Smart UPS 3000 Runtime Problem
Hi all,
I have a problem with the UPSs 3000 (Smart-UPS 3000 RM XL SUA3000RMXLI 3U).
I have had an alarm with "Discharged battery" on both of them.
I replace the batttery with a new RBC kit but still the same problem.
- Discharged battery
- The battery is too low to support the load; if power fails, the ups will be shut down immediately.
- Last Battery Transfer: Unacceptable utility voltage rate of change
- Input Voltage: 217.4 VAC
- Output Voltage: 216.0 VAC
- Runtime Remaining: 1 minute
I tried to run the Runtime calibration when I got 100% of battery capacity, UPS Self-test as I did usually but still the same error.
The LEDs are always flashing
I need help mays be I have to reset the APC after the battery replacement ?