Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84411members
353611posts

APC Smart UPS 3000 Runtime Problem

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

Solved
amihin_apc
Crewman
Crewman
0 Likes
1
360

APC Smart UPS 3000 Runtime Problem

This was originally posted on APC forums on 5/13/2015


Hi all, I have a problem with the UPSs 3000 (Smart-UPS 3000 RM XL SUA3000RMXLI 3U). I have had an alarm with "Discharged battery" on both of them. I replace the batttery with a new RBC kit but still the same problem. - Discharged battery - The battery is too low to support the load; if power fails, the ups will be shut down immediately. - Last Battery Transfer: Unacceptable utility voltage rate of change - Input Voltage: 217.4 VAC - Output Voltage: 216.0 VAC - Runtime Remaining: 1 minute I tried to run the Runtime calibration when I got 100% of battery capacity, UPS Self-test as I did usually but still the same error. The LEDs are always flashing I need help mays be I have to reset the APC after the battery replacement ?
Tags (5)

Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
360

Re: APC Smart UPS 3000 Runtime Problem

This reply was originally posted by Angela on APC forums on 5/13/2015


Please review this thread that I just responded to. http://forums.apc.com/spaces/5/smart-ups-symmetra-lx-rm/forums/general/10846/smart-ups-3000 My first few paragraphs and reference to how to handle a flashing battery bar graph would also apply to you.

Can you be more clear on what happened when you tried to run a runtime calibration and how you did it and with what percentage load?

See Answer In Context

1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
361

Re: APC Smart UPS 3000 Runtime Problem

This reply was originally posted by Angela on APC forums on 5/13/2015


Please review this thread that I just responded to. http://forums.apc.com/spaces/5/smart-ups-symmetra-lx-rm/forums/general/10846/smart-ups-3000 My first few paragraphs and reference to how to handle a flashing battery bar graph would also apply to you.

Can you be more clear on what happened when you tried to run a runtime calibration and how you did it and with what percentage load?