Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84333members
353500posts

APC Matrix 300 - Smart Battery - Work-Around

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

BuiDoi_apc
Crewman
Crewman
0 Likes
0
127

APC Matrix 300 - Smart Battery - Work-Around

This was originally posted on APC forums on 10/28/2011


I have been lucky enough to get hold of a Matrix3000 but have NO battery packs.
I DO have a BANK of batteries to the tune of 48V and 24KwH.. My simple thinking is that IF I could get hold of a Smart-Battery Interface board, then I should be able to treat the battery bank as an Upsized-Smart-Battery.

Anyone got any thoughts as to what I can't see wrong with this, and any idea where I can get the Smart-Battery control board..

I'm in Australia, and don't see any of these packs floating around, to give it a try..
I do see them in the US, but the freight cost is out of the question and folks won't "Remove" the board and just sent that.

Thanks for any advice..