Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Is there anyway to show more than two demical places in PME report?
Metering & Power Quality
Schneider Electric support forum about Power Meters (ION, PowerTag, PowerLogic) and Power Quality from design, implementation to troubleshooting and more.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Link copied. Please paste this link to share this article on your social media post.
PME report displays two decimal places by default. Is there any way to change the number of decimal places in the PME report? I have tried to change the configuration in reportpacks, and it starts to show four decimal places, but the last two decimal places are always zero, though the raw data is up to five decimal places.
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.