Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

Close
Important Announcement: WELCOME to the Schneider Electric Community! We have moved to a new address: community.se.com — bookmark it today and contact SchneiderCommunity.Support@se.com if you have any questions!
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
82759members
350548posts

One-Line and Riser Diagrams

LayoutFAST User Group Forum

The LayoutFAST User Group is a place where Specifiers, Contractors, and Panel Builders share their User experience with the tool and ask Schneider Electric experts questions to solve their issues.

MSchueler
Cadet
0 Likes
1
626

One-Line and Riser Diagrams

Good afternoon,

 

I was wondering how to go about substituting in our own symbols for the One-Line generation.  We sent out an email a while back asking about some of the features and were told that we would be able to, but have not really had the time to dive into it and figure out how.  Was hoping someone might be able to assist?

Tags (1)
1 Reply 1
FelixRamos
Lieutenant JG Lieutenant JG
Lieutenant JG
0 Likes
0
4

Re: One-Line and Riser Diagrams

Hi @MSchueler,

 

Customizing the LayoutFAST diagrams is simply a matter of editing the family.

 

  1. Select the symbol
  2. Click the Edit Family button
  3. Make the desired changes in the Family Editor
  4. Load the family into the project

When prompted, you will have two options:

 

  1. Save the updated family.  This will overwrite it where LayoutFAST will keep it stored on your PC.  Future use of the diagram tool will utilize your updated version.  (Note: the updated version will get overwritten when LayoutFAST updates are installed.  Users should keep a copy of updated RFAs in an alternate location.)

 

  1. Load the family into the project without saving.  This will update the family in the project only.  Future use of the diagram tool in other projects will utilize the original symbol families.

 

Please let us know if you have any other questions and thanks for using LayoutFAST!