Ask our Experts
Didn't find what you are looking for? Ask our experts!
Subscribing is a smart move!
You can subscribe to this board after you log in or create your free account.
Invite a Co-worker
Send a co-worker an invite to the portal.Just enter their email address and we'll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
Recommended Forums
Link copied. Please paste this link to share this article on your social media post.
Link copied. Please paste this link to share this article on your social media post.
Hello Javier
Is there device info/model info or a screenshot you can share regarding the connection you're trying to form?
There have recently been a lot of changes to ITA in regards to networking features and connections including the ability to specify the connector ends which no longer need to match as seen below. The below is from ITA 9.3.0.
It is possible we're missing some connector types, as if you can provide specifics regarding the connector we can request they be added to ITA, usually takes one or two releases for new connector types to be added once requested.
Regards
Greg Sterling
Link copied. Please paste this link to share this article on your social media post.
Hi Greg,
we have to model a fiber distribution frame with fiber optical fusion shelves. I have attached a picture of this shelves:
You’ve reached the end of your document
Create your free account or log in to subscribe to the board - and gain access to more than 10,000+ support articles along with insights from experts and peers.