EBO 6.0.4.90 AS-P demo license works after reboot, then License Violation appears

[Kleroman]

Hello,

I am testing EcoStruxure Building Operation 2024 / EBO 6.0.4.90 with an AS-P.

I added the demo license file in Device Administrator: "DemoLicenseEmbeddedEBO2025andOnward_valid_until_2026-07-01.bin"

Then I assigned it to the AS-P according to the Help procedure. 

In Device Administrator the server state is OK, and the license status shows Demo license.

After rebooting the AS-P, WorkStation initially shows the green banner,

BUT after about 3 minutes, the green banner disappears and the yellow banner appears:

  License Violation/ A License violation has been detected.

Could you please advise what can cause this behavior?

Why does the demo license work for a few minutes after reboot and then change to License Violation?

Screenshots are attached.

Thank you.

[CraigEl]

@Kleroman It's possibly the time and date in the AS-P is not correct after the reboot. Check what time and date the AS-P thinks it is following the reboot, it possibly is prior to the license activation date.

Incorrect Automation Server date and time leads to license violation - Schneider Electric Community

[Kleroman]

Hi Craig,

Thank you for the suggestion.

I checked the date and time on the AS-P after reboot. The date, time, and time zone are correct. 

[janim]

Put latest hotfix to AS-P 6.0.4.16000. Earlier hotfix contain license fix. 

[Kleroman · Accepted solution]

Thank you all for your help.

The issue was caused by the demo license file. I received a new embedded license file:

EcoStruxureBuildingOperationEmbeddedLicense_valid_until_2026_09_01.bin

This license is valid until 2026-09-01, and after assigning it to the AS-P everything works correctly now. The green demo license banner stays active and the License Violation banner no longer appears.