Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

Close
Important Announcement: WELCOME to the Schneider Electric Community! We have moved to a new address: community.se.com — bookmark it today and contact SchneiderCommunity.Support@se.com if you have any questions!
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
82658members
350359posts

SRT2200 / SRT3000 Configuring Outlet Group to switch on after mains input present

APC UPS for Home and Office Forum

Schneider Electric support forum for our APC offers including Home Office UPS, Surge Protectors, UTS, software and services and associated products designed to share knowledge, installation, and configuration.

Solved
Rooster_apc
Ensign
Ensign
0 Likes
1
183

SRT2200 / SRT3000 Configuring Outlet Group to switch on after mains input present

This was originally posted on APC forums on 4/7/2017


Hi. we have a number of SRT2200 and SRT3000 UPS' all fitted with NMC2 Management Cards. I need the Output Groups to automatically enable once mains input is applied. I've been through all the options in the Management Card (V6.4) but cannot get them to do this. Am I missing something? Thanks.


Accepted Solutions
BillP
Administrator Administrator
Administrator
0 Likes
0
183

Re: SRT2200 / SRT3000 Configuring Outlet Group to switch on after mains input present

This reply was originally posted by Vinay on APC forums on 4/7/2017


Hi Richard,

Outlet groups are turned on automatically until and unless they are configured to be in off state. Make sure the outlet groups are turned on and the "stay off after power returns" options is unchecked in the outlet group configuration section.

See Answer In Context

Attachments
1 Reply 1
BillP
Administrator Administrator
Administrator
0 Likes
0
184

Re: SRT2200 / SRT3000 Configuring Outlet Group to switch on after mains input present

This reply was originally posted by Vinay on APC forums on 4/7/2017


Hi Richard,

Outlet groups are turned on automatically until and unless they are configured to be in off state. Make sure the outlet groups are turned on and the "stay off after power returns" options is unchecked in the outlet group configuration section.

Attachments