Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

  • Explore the new navigation for even easier access to your community.
  • Bookmark and use our new, easy-to-remember address (community.se.com).
  • Get ready for more content and an improved experience.

Contact SchneiderCommunity.Support@se.com if you have any questions.

Close
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
84643members
353977posts

SURT10000XLT Run-time calibration

APC UPS Data Center & Enterprise Solutions Forum

Schneider Electric support forum for our Data Center and Business Power UPS, UPS Accessories, Software, Services, and associated commercial products designed to share knowledge, installation, and configuration.

fishkillr_apc
Crewman
Crewman
0 Likes
0
111

SURT10000XLT Run-time calibration

This was originally posted on APC forums on 12/24/2015


SURT10000XLT,  SN:NS0623003696

Rack mount unit with 4 XR battery cabinets, with a total of 10 recently replaced RBC44 battery modules. The unit is not reporting the correct run-time. It's backing up some critical equipment that we are un-able to shut down so we would like to re-set the battery constant as outlined in the APCUPSD manual. We've been successful in doing this before, on smaller SU's, using the values in the manual. There isn't a value listed for an SURT10000XLT but there is one for an SURT10000XLI. Can I use the XLI value for the XLT? If not can you PM me the correct value? 

Thanks,

Jim