Welcome to the new Schneider Electric Community

It's your place to connect with experts and peers, get continuous support, and share knowledge.

Close
Important Announcement: WELCOME to the new Schneider Electric Community! Community is now no longer part of Exchange, and is now rebranded under se.com. If you have any bookmarks and links saved, we request you to update them to ensure that you continue accessing our community from this new location. For any issues that you might encounter as part of this change, please reach out to SchneiderCommunity.Support@se.com, and the team will help to get your issues resolved.
Invite a Co-worker
Send a co-worker an invite to the Exchange portal.Just enter their email address and we’ll connect them to register. After joining, they will belong to the same company.
Send Invite Cancel
82473members
350045posts

Symmetra LX, power failure fault

APC UPS Data Center Backup Solutions Forum

Schneider Electric support forum for Data Center UPS, software and services including our APC offers designed to share knowledge, installation, configuration, and general product use.

BillP
Administrator Administrator
Administrator
0 Likes
0
46

Symmetra LX, power failure fault

This question was originally posted by Mohanprasad on APC forums on 2/19/2016


we are the authorised service provider for single phase ups APC product in Oman,

recently we went to start up Symmetra lx 8kva ups, but it was purchased 2 years back, now they are called to start up, from 2 years it was off condition. i turned on this ups, after 2 min it is going to battery mode, and i checked in faults and diagnostic showing no faults, and i checked through NMC and showing input power failure fault, even input is there with 235vac,i turned off and again turned on, ups is turned on after 2 min again going to battery mode and showing input failure fault in NMC home page, but in ups display still showing 235VAC input. after some time battery discharged fault is coming, and battery run time showing 0hr 7 min even after putting to charge more than 5 hr run time is same only not increasing.

please give me the solution, which one is problem

Tags (1)